Recent content by DanT55

PETG is what they use for water bottles, cosmetic jars, etc. It is a very tough and resilient material especially if loaded with reinforcement. I would have no concerns with it in this application. Its a good choice.

How many ways can they describe a Tesla gas diode? it is unique to their rifle and moderator. Big deal. Can you quote something they copied?

The Tesla gas diode is open source and not on patent currently since it has long expired.

What was the barrel twist for these? Thanks

Did you get a chance to check out or shoot the EVO Bill won with?

The feature set, power potential, efficiency and configurations are pretty damn impressive...on my list...could be my first 9 mil. Good work RTI.

That's a lot of rifle for that scope! 🤣

Hello, Love this little rifle still! Looking increase plenum size on my old .22 Mutant standard. It came from the factory with a small aluminum spacer to offset the reg from the valve housing. I also think it has a step inside the pressure tube where the reg stops so probably limited to an...

It is actually a beautiful piece of lock work and leverage. Like a fine watch. Leave it alone and be happy but if your inclined and have patience trigger nirvana can be reached.

This

Thats awesome! Unfortunately the poor kids these days would end up with a SWAT team rolling into their neighborhood after some Karen called them in.

In my .25 I made the mistake of going higher on the LP (130 to 160) in relation to the HP (1400 to 1500) and could not get the results I was looking for. I followed your lead and dropped the LP down to about 105 and the LP to 1400 with a dwell of 23 and easily hit 890 with 33gr JTS's out of the...

Could be the poppet seal inside the reg as mentioned above on MFE 105. You can pull out MFE107 then pressurize and if still leaking its probably from the poppet seat per SKOUT or turn it in to reseat and then reset desired pressure. You can get 9006 apart but will need some non-marring plyers...

Looks like they still have them on..they are really air strippers due to the internall design. They do mitigate the report but not as quiet as some witth the felt liners, etc. There is room to wrap some insulation around the perforated stripper tube or put in their whisper baffles. Try one...

The settings are programmed into the EPOCH screen and can be adjusted from 10-50 in increments of 1 in program mode. The valve and transfer port are very large relative to other PCP designs. It seems to work well with their valve and flow design. I believe the dwell in this case is how much LP...