Recent content by SilentSquirrel

What a shame A legitimate business must close down a vital means of communication with clients because some skanky ho's keep scamming, spamming, phishing him. Where is the ICC when you need it? just my 2 intense Edward

Why am I not surprised.? Lots of problems with stiffness of the AO but not a single account of having talked with Hawke about it

PM on the way Thanks Edward

YES! That's it!

Thanks Most appreciated Also note I made an edit The ball I am seeking is in the Burst Disc Assembly that is next to the grease pot

Hello members I have managed to lose the ball that is in the check valve of the CS-4 So, when the chuckling stops, I'd like to know the diameter & material in order to find a replacement, please. Any help. including links appreciated EDIT The ball in question is the one that is part of the...

This listing has been renewed

When filling from a tank I use a fitting with a flow restrictor to help slowdown and control speed of the fill Here is one from Pyramyd Other suppliers may have them as well https://www.pyramydair.com/product/air-venturi-foster-female-quick-disconnect-to-1-8-bspp-male-5000-psi?a=4926 Edward

This listing has been renewed

6/28/25 6:35pm EDT Only 30 votes so far. Does the post get bumped to extend the survey if there are not many votes? just my 2 curious Edward

I am about to take a look at the regulator in my Crown MK II The reg pressure follows the gauge pressure down. No matter whether I rebuild or replace the regulator the question is: Does the tiny O-ring in the block need to be replaced either way? Thanks Edward

HERE IS @MELOS post translated to English (AI) I also have a 2018 FX Crown MK1, and the same problem occurred to me after looking for information about the regulator installation, looking to improve the rifle, he came to the conclusion that I would opt for the original spare part. Depending on...

following with high interest.

This listing has been renewed

This listing has been renewed