Recent content by zx10wall

A few photos:

Thank you Ron. You always put on a great event. Extreme FT it was; extreme mud & heat coupled with extreme fun and extremely great folks. Hey, all the snacks and beverages coupled with a 69° house to catch a break in at Ranchito Robinson, makes this a top notch venue. Despite all your “rough...

IN

I would say that does look to be an honest review. To add a critique; his rear rest isn’t doing him any favors! On a lot of those shots, his sight picture went from on target to 2” high of target after the shot. This screams that his rear support isn’t adequate and he won’t get consistent...

Hello there. I’m actually also a dealer and own Tenacious Airguns. I acquired 2 RPs and I am keeping 1 for myself. The other was sold to a teammate. I would have gotten 10 if I could have but I can’t swing that cost. I’ve had one session with the RP. I shot those groups and was impressed. Keep...

Great point also! This is why, IMO, some diabolo pellets, when not shot from a proper twist rate for it, will begin to corkscrew down range! The speed is being scrubbed off very quickly but as you've indicated, the spin rate (RPM) is retained longer. Some call this over-stabilized.

Great point!

I've found that BC does change at different speeds when using pellets. Take for instance, 18.13gr pellets have a surprisingly good BC, for what they are, when shot with a MV from 825 fps to 930 fps (27.5 FP to 35 FP). Lower the speed to 700 (20 FP) and your BC plummets to that not even as good...

Good investment!

Fill to 260 bar and shot to 2nd reg:

Any PCP pressure vessel getting shot with a .556 is gonna fail! It doest’t matter where it was made but anyway!

He said on the video, “would it blow you up, I think it would‼️” He knew it was gonna be ugly.

I concur. The one I have is stellar. Very good! Don’t drop it though‼️

Downstream of the valve, you have a large exit port which can rotate and choke off flow. One you have it set to your liking, the Red Panda has a feature that locks the desired position of the transfer port. This adjustable transfer port sends unfolding air into a cylindrical chamber that...