Search results for query: *

My Impact MK II .22 cal. hits about 1.25" LOW (3.5 mil) at 10 meters when sighted in for a 25/50 yd zero. That's with 25.39 gr & 18.13 gr. pellets going about 940 fps.. The scope height is 2.75". I use mil dot hold over so can't say what affect that would have with dialing for a crosshair hold.

I have ordered FX parts ,twice, from Utah Airguns recently and had quick and courteous service. Prices were about what I paid at FX USA. They even went to the parts bins to check out the specifications on a part I had questions on.

.25 cal breech O-ring is a 6.35 x 1.27 mm or 11/32" x 7/32" NRB 70. You can find that at Menard's or most hardware stores. To install you will probably need to take the barrel off so you can get at the breech end. It can be a bit tricky getting it in there.

IN

IN

:)

I was going to order, but then I realized it didn't come with flashing Disco lights. Oh well , maybe next year!

I think it depends on how you visualize range. If you see something at 265 yds you know 1 MOA = 2.65". 1/4 MOA = about .7" . How much does a MilR = at 265 yds? However, at 265 meters you know 1 MilR = 265 mm and .1milR =26.5 mm. Both work fine if you use the same system to range and adjust...

I fill mostly from an Omega 75 cu ft tank that is filled from a Omega Aircharger compressor. Gives me 4 fills of a 580cc bottle run down to 130 bar from 250 bar. Takes about 15 min. to fill tank to 303 bar (4400 psi) from 250 bar (3630 psi)

Thanks for getting back to us with a solution. To many times on forums people seek answers and never tell us what the solution to their problem was. Makes that thread pretty much useless to the next guy with similar problem. Good Shooting

What type of ammo and at what velocity? With only 80 psi on regulator your hammer MIGHT BE opening the valve completely at the lowest setting and all other settings have no further effect. Try reducing the hammer spring compression by adjusting the micro wheel in front of the hammer adjustment...

If the lines are 0.4mil thick, at 100 yds what is the subtension at 24 X ?

Looks like all those lines are real usefull at low magnifications. LOL

Surprised that so many members on this forum use an ANTI GUN contributor like Pay Pal for doing business.

Buy a Lyman/ RCBS lead ingot mold for a few bucks and all you have to due is flip it over to get the 1 lb. ingots out. 

$1627.30

$126.57

Thanks Fella's: That's what I was afraid of. Never did like that pistol grip on the original stock . To large in diameter and to far back from trigger. Also seemed to have more wood in the forend than was needed.

What's the difference between the two generations? Will Gen 1& 2 stocks interchange or are the differences internal. I know they changed the receiver mounting screws from two to four so the pressure tube mounting holes are different and the tubes are therefore not the same but I believe the...

$2756.69