Search results for query: *

No, I have not tried 16gr ZAN's in P35. It is performing very good with 3 different pellets with one tune. Maybe I will try sometime.

I also lightly polished the barrel to smoothen out tight spots when pushing pellet through barrel. Air passage from valve to barrel transfer port, if I remember correctly, was 5mm ID. I bored TP of the barrel to 4mm and also enlarged hole (downward facing hole, air passage) in pellet probe.

I made similar thread. https://www.airgunnation.com/threads/spa-artemis-p10-p15-p35-tuning.1282196/#post-1405922

I have set up my Snowpeak P35 (.177) to shoot 3 different pellets with the same tune. JSB Monster, 13.43gr @869fps JSB Monster RD-s 13.43gr @858fps JSB Beast 16.20gr @808fps Scope zeroing for those 3 pellets is same, 30m/32yd. With Monster&Monster RD it holds zero (no need to hold or dial...

What is available is difference between Huma MK3 and MK4 regulators:

As far as I know there is no Gen 2 on block. Regulators only differ in time. I asked from AirMaks:

550cc of air? I guess air tube + air reservoir around barrel + plenum (situated where Impact M3 plenum is) or that tube like thing under the magazine area???

Got mine few days ago. From Krale.

No, short answer is - Lite is without externally adjustable regulator. It is mostly for UK, sub 12 ft/lbs market.

On my KRAiT L, I use Huma-Air MOD30-3/0 Avalanche (Compact) .177/.22. I did little felt modification to it and it is mouse fart quiet. MOD30-3 series is same OD as KRAiT's shroud OD, so it is like one piece with shroud.

My FX Dreamline GRS with Maverick dual reg. system. .177cal 600mm STX Superior Heavy for 20gr ZAN slugs.

Our cat came inside with a mouse and lost it. I found the mouse sitting under couch, in the farthest corner. Did not want to scare the mouse to run away. Took my longest rifle (FX Dreamline GRS, 600mm barrel, .177) and moved muzzle as close as I could. Then dryfired at the mouse and that blast...

I heard that. It's a good reason to search the coupon then. :)

Air Shootist mentions 100$ case in His video, starting @8:36.

I have the same question - are those challenges pellet ONLY or are slugs also allowed? IDK, is it easier to do new/separate challenge or different leader board inside existing challenge? Projectiles are marked on target sheets, input data from there.

ONLY pellets or .177 slugs also allowed?

By measuring shroud and muzzle end, I came to conclusion that for 20mm OD shroud the ends are threaded with M18.5x1.5 thread. I see that FX like to use unusual Metric threads. There is tap for M18.5x1.5 on amazon. https://www.amazon.com/Aceteel-Metric-Thread-Machine-M18-5x1-5mm/dp/B0C7BG6FLC

20mm or 28mm OD shroud? For 28mm OD shroud it says Metric thread 26.5x1.5, both ends. Quick search did not gave any answer for 20mm OD shroud end threads. And I don't have right thread gauge in hand to measure my 20mm shroud.

NBR70 or NBR90 grade O-rings should last.

And most importantly tell Him that You have to center the barrel from BORE, NOT from outside surface. Jeff can show You: