I put extended life antifreeze/coolant in mine instead of water because my compressor is out in a minimal heat shop.

I went with the bottle brush method for de-ping. I got one with a slightly larger diameter than that of my air tube. I then cut about a...

Always wrap a cloth around it first before the Pliers.

You might try what I said report 1 thread and tell the moderator that you are getting notifications for every single thread posted maybe...

Is the barrel oring in the breech still in good condition or missing?

I have the Avenge-X. The end cap does come off but I had to heat it up with a small propane torch a little bit. It was red loc-tite on...

As soon as a new thread is posted I get a notification and I don’t even open the thread.

Pcps, The YongHen compressors are affordable at $300. Walmart can get them ( with guarantee ) . You have to be careful and follow the...

I’m not sure that will work as the mod must tighten against the CF shroud to tension the barrel.

LOL. Oops. I thought I didn’t get them in the picture.

I used Vortek seals because of the fitting issue. I don't have a lathe but I figure I can take one down to size with a drill and a...

Exactly the reason I am looking more seriously into Airforce rifles.

The link states that the Zelle app no longer works. If you want to use it you need to have a bank that uses it as a payment.

This listing has been renewed

There are 2 springers that fit the bill. The R9 in 22cal. It has the harder hitting power at 30yds than the .177 caliber. Check out...

If you've never had one you're going to be a happy camper! I've been in love with my 500 & Boss since day one. Never let me down! HAPPY...

14C 987hpa 38%. Reg 166 micro slighly less 3 (33g hammer). 960fps. 120m(7° slope)

Good looking gun feet not so much :)

Well thats really weird not sure what you can do, maybe go to 1st post in thread and click on report at bottom of the thread. Tell them...

Here’s what I purchased a few weeks ago. FX Royale 400 .22

Major congrats!!! Yours is the first tactical BW that I've seen in the hands of a consumer. The chassis portion that holds the action...

I've got a stash of FTTs, JSBs, crosman premiers, and a bunch of polymags! Lol. Oh don't forget Barracudas. Even have some of the old...

Thanks Ron I'll see if I can straighten it out! Probably will be loosing the sights and getting scope soon. My old eyes don't do well...

Have you tried putting a small o-ring around the base of the male threads the moderator screws onto? Sounds overly simple but helps with...