It sure looks like it rubbed a groove in the bore dang it! I'm wondering if the pin is part of the valve or what.

My minimum distance is 50 yards, most are 100+. But the MIA are pretty equal at either distance . Say 50%.

I found another option at an affordable price, the Reximex Daystar. Has anyone used it? I haven't found much information about this rifle

He has the new hp high power version. Reg can go higher than the standard version.

Like this one?

I'm zeroed at 100.... and running an Ivey Adj. scope base for ELR......and like some have mentioned, Ballistic apps are extremely...

I replaced the stock air cylinder in my HW100 KT with the Ratworks FAC XL and IMO it improved the looks of the rifle and like you said...

You have to put it in the classifieds not here.

Nice set up didn't you just get a stool? or just prefer the bucket? :unsure:

If the guides fit right, that will dampen the twang, thus eliminating the use of tar. I use Krytox or Ultimox it doesn't combust. And...

Same...

Not quite catastrophic but definitely significant. Did it damage the receiver bore? I still feel that something must have abnormally...

Actually, I'd say screw airguns and use my Savage A17, but.....the dog on the property that goes nuts with firearms is still breathing...

Same thing happens to me when I use a clamp-on chronometer, and for free floated barrels/shrouds the slightest bit of cant and magnify...

AGN does not advertise their guns.. They let the guns speak for themselves :) and this is the best advertisement... Just the news from...

Sorry I don't know what you guys are talking about...I received the tube and Installed It , done

For me the trickiest part of springers is trying hard to not cut or nick the piston seals on all of the sharp edges. We used to use cut...

Thanks, l should have read all and stop scanning!

YES, Don! 😊 🔸I consider the minimum focus or parallax that important that ALL scopes in the Scope Specs Table have 10 yard min...

Webley did do a few Mk3's with pretty walnut, didn't they?

The springs in JM KITS are pre set. Don't attempt to set a spring without a fairly snug mandrel. The spring shown may cause graunchy...

Not to take away from the bench, but that is the nicest bucket seat I've ever seen.

Remove it, makes bench shooting with bags much easier. I am surprised the 3D printer guys haven't tapped into stock making.

Looks like the opening valve failed. Pretty sure the little pin isn't supposed to be sticking out the side.