sorry , but next time take pictures and use small bowls for say trigger parts in one bowl . This is the only way i take guns apart .

And...the Ataman AP16. I have two. Another...very nice pistol. I think that the Tequila Gun is also right up there, in quality and...

Ola.

That bushnell is not a springer scope. The cheapest good springer scopes are the UTG 30mm tubed models. If you get an RWS locdown...

HAHAHAHA , wonderful

I don't know about the Bushnell. Barrels on those guns droop. Even if they don't a few degrees "down in the front" gives you more...

Welcome to the best AGN . did you check all the mount screws ? are they torqued properly ? also run a few patches through the barrel...

:LOL: Birkenstock synthetics

I guess I was one of the lucky ones. My .22 FAC full length HW100 is a tack driver. It did take me a while trying various pellets...

Awesome Awesome!

That is the best diagram available. It shows all of the springs and where they fit. If you cannot repair your pistol with it then take...

This listing has been renewed

I appreciate the quick responses! A few more details: I bought the scope off Amazon and the 30-day return deadline was pending so I...

I may have posted about this on Air Gun Nation before, but I'll repeat: I have an older RWS 94 in .22, which is a coil spring Cometa...

Depending on your eyes, it gets pretty difficult beyond 45 yds with ANY scope at 16x. It takes a lot of practice. Look for something...

What exactly was unreliable about them? Seal failure... Valve failure?

when you fill your gun direct,,, it has a check valve in the gun well it is the same principle,, it holds the air in the tank when the...

Hi TORS - Darion, Does either the Pro-Grid or Booth measurement tools have the ability to correctly size an old/deformed o-ring or an...

Mine is the HE507C-GR X2 and it has the slide out battery compartment so this 507 doesn't need to be removed for battery replacement.

The problem is sorted, yes. Just had to pop out the plastic bit by inserting 4mm allen wrench from the bottom and give it a good thwack...

You said nothing but truth! Many start off with a budget gun and progress upward in quality at the behest of skepticism. Others may...

Good info! I'm using a 6 3/4" wheel, which gives me about 3/8" between 50 and 55 yd marks. Depending on lighting and fatigue I usually...

Nothing too shabby about a 199-17x Jim. Shot two 198’s this morning and if wind was light, I think I could have had a couple of 200’s...

Youtube says remove stock and you will see the tensioner. 🤔