Recent content by 1975HW55

Had what I needed; shipped it fast.

Either way a project. Need a hacksaw hole saw blade exactly the right size. Forks plug has a slight taper on end that creates a thin groove around the outside edge between the plug and the tube. Interesting result. The leather piston seal forms a short thin lip around its outside edge from...

Material is gold colored after rubbing with sandpaper ring on end of a dowel. Brazing ?

Synthetic, yes. Leather no. Been shooting it since I bought it used in early 70's. Use Robert Law( old ARH) silicone piston seal oil. Getting low though. If anyone knows what is in that stuff please let me know. Thinking I should remove the lump though as you suggested. Leather piston seal in...

Hi Gentlemen, another question. 1960's HW35E found at gun show in early 70's Did a Robert Law(old ARH) Super tune myself back then. Rifle has been shot a lot!!! Just took apart due to sudden velocity loss. Needs spring. Lump of metal at 12:00 above transfer port at juncture of end plug and wall...

Done. Thanks again !

Many heads are better than one. Thank you gentlemen ! With a combination of tips from all of you parts were removed with minimal damage ! It is a press fit with a key in the lever and a keyway in the shaft. Back together as you can see. You can be sure I will be checking the lever retaining...

Pictures. Will not push or tap back on. Will not pull off.

Help ! Barrel latch screw was loose. Did not notice. Barrel latch lever now stuck halfway on/halfway off shaft. Too far off for threads of retaining screw to engage threaded hole in shaft lever is mounted on. Lever will not come off or push all the way back on. Suggestions anyone ? Thanks !

Sorry, new to this. Will not go back on, will not pull off. Stuck halfway off. Replacement parts seem to be nonexistent. Will move to traditional airguns.

Help ! Barrel latch screw was loose. Did not notice. Barrel latch lever now stuck halfway on/halfway off shaft. Too far off for threads of retaining screw to engage threaded hole in shaft lever is mounted on. Lever will not come off or push all the way back on. Suggestions anyone ? Thanks !