Recent content by Airfuture

They are protected by an outer protective layer "Stainless steel look" they are not built from stainless steel because they would be too expensive, but it is definitely better protection against burnishing...

https://myhighpressureair.com/skout-tesla-moderator/

I have not done a speed test with dry ptfe powder vs moly paste, but I will do it as soon as possible and publish the results.

Maybe I expressed myself wrongly, but the moly lubricant decreases significantly when it reaches the compression space. In any case, the friction coefficient of PTFE compared to Moly is significant.

I think that the lubricated piston seal leaves all the lubricant behind on the dry cylinder during installation...

Yes, I also use moly paste on all other moving parts, but I also like my compression chamber to be lubricated ;)

I have been servicing all types of air weapons for many years and in the last year I have been using PTFE dry spray when I install a piston with a new seal after cleaning the compression chamber. The assembly is easier and most importantly there is no dieseling, occasionally I lubricate my...

Maybe SPA will start producing a slug barrel.

http://www.snowpeaksports.com/series/details/198.html

Hosea 12.7

Yes, I replaced those two models, sorry.

Wasn't it announced at half the price? https://www.pyramydair.com/product/karma-red-panda-bench-pcp-air-rifle-pellet-barrel?m=6274

I believe you will have better prices than these because you don't have VAT like the EU has... https://www.rojal.si/hr/zracno-oruzje/airrifles-hr/pcp-hr-2/zracna-puska-rti-mora-22-standard60cm-24/

I would rather say 3 milliseconds

Here is your chance to show and prove your superiority over other ammunition manufacturers, you have the correct caliber, you still need to know the twist rate... The only question is how consistently Skout produces barrels, i.e. what are the caliber deviations, I strongly doubt that every...