Airgun-hobbyist's latest activity

@Blueduck Two things... can you give is a fairly accurate measurement from the top of the picatinny rail to the bottom of the scope...

Thats awesome! Many people rag on aea and bintac products. I have never had an issue that couldn't be resolved. I spend time setting...

I know that it is possible that it might not have been user error from direct experience . . . I had the firing valve on my Huben K1...

So Friday turned out to be a somewhat productive day after all. Zeroed scope and adjusted hammerspring on Puncher Breaker .25, shot 7...

Man that’s impressive. I consider it a good airgun day when I open my safe, stare at my collection for 30 seconds, then close the safe...

PB shooters have been using pure copper strands wrapped around a brush for fast removal of lead for a century or more. It is the...

There are a variety of possible reasons. My recommendation would be as follows...before scrubbing out the leading, advance the...

JB IS NOT abrasive enough to remove lead fouling !!! Use a Bronze brush and any marketed lead softening/ removal solvent. Patches alone...

Had a Buckrail module on my Daystate revere 25 and it did a moderate job. Wanted to see if there was something better. With all the...

@Rickstwowheels So long as there is no interference in regards to projectile clipping or on accuracy then you should be fine. Knowing...

How is the accuracy? Air strippers have about that level of clearance.

(Bob, apparently I type really slow and was formulating reference to my archery training as an example while you were posting the same...

This is similar to what we'd do on an archery target as well. "Float" the sight on the target dot concentrating on making smaller and...

#1 = a field target that has a hole dia. of .22 size pellet, so if ya miss with a .177, it is not falling down. It is def a challenge...

Dirty filthy pigeons! LOL