Recent content by airgunutty

I went with the bottle brush method for de-ping. I got one with a slightly larger diameter than that of my air tube. I then cut about a 3 inch piece and inserted it to a little more than half way on mine, so as to not interfere with my regulator. Works superbly. Added benefit of using the bottle...

🤣🤣🤣 That is so true. I love it. I do love to make life harder for myself it seems. Thanks and no dampening here. I truly appreciate your taking the time to respond and give out good advice. I do limit my destructive tendencies to projects that I am fairly confident of successfully...

Well said and I know all of these suggestions do make any mechanical task less daunting. Unfortunately my particular problem is I suffer from lackapreparation and one of the side effects are impulse disassembly. Sure it's treatable with enough self induced headaches and a litany of profane words...

Could not agree more. My first tear down was a marksman 0035 . It was a simple seal replacement but the act of doing the work made me feel like I could also fix other problems that would undoubtedly arise. Not to say that I didn't whack my head on the wall several times but in the end to...

Thanks for reading and responding to my post. Sorry to hear that you also suffer from photo-phobia. 😁 Go to the springer section of this forum and start asking the members. I promise that someone knowledgeable about the issues you're having has been in a similar situation and will be happy to...

Coincidentally the same thing happened to me when I attempted to rebuild an air venturi g7s hand pump that a super nice awesome member of this forum sent to me so that I could start my pcp journey. On that one I got the check valve upside down. But now I have the confidence to do the necessary...

Well I finally conquered my anxiety about tearing my new Hatsan At44 177 down. I had been trying my best to ignore the crunchy grinding sound each time I pulled on the cocking lever. I thought it's new and just needs to be broken in. Well after about a thousand shots and still crunchy bunches of...

Mine came in two boxes. A smaller one that the unit was in and the other slightly larger one was the shipping box. So I cut the front and back out of it water proofed and viola shade for the chrony.

There's calculators on this main page.

Just got one for 32.00 off amazon. Seems like a good purchase. Seems to be working but without having another to compare it to can only assume it's accurate. But adjustments to the hammer spring are seen in the data. I'm calling it a successful thrifty purchase. Chronos make the rabbit hole...

🤣

Thank you for taking the time to share what techniques work for you. I am always looking for ways to help me improve my shot. Just got a chrono so I'm going down the rabbit hole of hammer spring adjustments and thoughts of setting my regulator to a lower psi. Good thing I'm not in a hurry. I...

Thank you for that advice. I'm new to shooting and I do it alone so I don't know what I don't know yet. I have an hatsan at44 long qe and with scope comes in at just under 11lbs. Plus its kinda front heavy. But to say it's difficult to hold crosshairs steady with it is an understatement. But I...

Thank you for taking the time to break that down for me. I guess I will make a chrono my next must have item. Thanks again

How can that be? Perhaps my terminology is off, I'm a newb. I have the hammer spring turned clockwise all the way in and pre regulator was getting 50-55 shots. After regulator installed shots dropped dropped off to 40. By turning the hammer spring counter clockwise the shot count continues to...