Recent content by aklonewolf

I hade a Vega. It was a good running car.

The submarine I am building has some faults, but let me make a contribution to your favorite charity and maybe you can get things going. At the top.

But to give a review and "leave out the cons at the behest of the company is wrong, is not right." And to the Administrators here, if you know that there is an issue with a particular air gun or product and you still allow these one sided reviews that benefit the company that they are...

Agree. What there doing is deceiving the good people on this sight, and that could be fraud. Slap a law suit on them, and they will either do the right thing or get out.

Well, if my m3 sat for an hour or longer the first several maybe ten shots were off target. That was unacceptable, I red about the first reg delete and that’s what I did. That solved the problem. Instead of buying the m4 I figured I would just upgrade my m3. I think the 600mm barrel is a good...

It could be the little screw that holds the pellet probe in place.

The M4 parts are not out yet, give UA a month or two and the part that you want should be arriving. I want the same part. Patience grasshopper, the m4 has just been released.

I have a compact M3 .25 cal 500mm barrel. I purchased an stx barrel kit 600mm from Utah Airguns. Should I just go ahead and re-tune it? I have been using the Kings 25.39gr. Has anyone found a better, accurate pellet? I have done the first reg delete.

A squirrel.

I just ordered a GX PUMP CS4 Portable PCP Air Compressor. Good reviews and people here like it. Now I can get a scuba tank and top off my air guns with that. I used the rebuild kit, and replaced the high pressure springs or whatever their called, but nothing still not building air. I am going...

I like that one, you can fill an 6.8 L tank.

How has that been running?

Sounds good to me.👍

Well, mine stopped building air last week. It will run but no air pressure building. Like the other guy I called the number in the owner manual, they sent me a parts diagram and asked if I wanted to send it to them for repair. I have only found one rebuild video for that compressor. Do you think...

Question 1- Answer, the reason why 250 bar max is etched into and by the air gauge is because, the air gauge only goes to 250 bar. If you look on page 8 of your user manual it says, max overall pressure not to exceed 300 bar. The bottle says 300 bar. It is safe to fill your m3 to 300 bar, just...