Recent content by alpineboard

Hi Everyone, I have an interest in 50 yard Standing position, and possibly 100 yds, using a 177 FWB 800x, and 900, both are 10 meter setups. For my son and myself. Last outdoor season I used a FX Crown GRS in 22 cal, 700 1:16, 27g slug, at approx 950 fps, for this same Standing situation at...

Very interesting, I am curious about any details.

During the winter season, I am doing indoor 10 meter standing with an FWB 800x, Last summer, I did Standing with a FX Crown 22 GRS, 700mm, @ 50 yd, 100 yd. learned plenty, and did enjoy everything about it. Planning to try 50 yd , 100 yd standing, with the 177 FXB 800x, which is factory set...

Curious about the fwb 800x ability to reach out to 50 yards. I guess the question would be, is the field 800 tuned the same as the 10 meter, same hammer/spring and internals? A chrono of each would tell. Jump to 5:40 minutes for test fire at 41 meters, interesting.

Due to a few changing circumstances, example being 1 more additional shooter. And would like to both shoot at the same time, etc I would like to see how the FWB 800x, FWB 900 ALU, both are .177 and are iron aperture sights, , will perform at 50 yards in the Standing position. The only...

I have been using rubber mulch traps for outside summer. For indoor 10 meter I have had good results with Industrial conveyor belts, mining and woodchips. I get some bounce back, but control that with poster board political signs, and use gorilla tape when the holes get big. I have as low of...

2 shots Standing 10 meter air rifle, fwb 800x, happens frequently, but this looks like one hole.

IMO, do not say a thing, once the cat is out of the bag, you are done. And you will wish you never said anything. If either one of them is into airguns, chances are they are not. They will know what you are doing, and be fine with it, without talking about it. If you are legal , there is...

here is my setup, am going to change to a single post standing rest stand soon. Also planning Electronic scoring Fre E target method.

Have been back inside for 10 meter standing for a couple months now. Starting to get it together, Big level increase in the area of breath control, doing hold /release 6 second with 0% air in lungs, so much more comfort in all the sequence, very relaxed. Score is still the same, but give it...

Or Grace ice and water shield for a big job.

I have something from the PlyLok family. https://fennerdunlopamericas.com/markets/wood-log-and-paper/

Industrial conveyor belt material, for mining, wood chip power plants, firewood processing, etc. I came across this at a swap shop. Looked it up, and is very expensive, not sure a minimum can be purchased. Thinking it is north of $30 per square foot. However , it is the best material that I...

I did get the Boss trigger installed on the crown grs, some dremel work on the interior stock, and interior of the trigger guard was needed. The grub screws that were sent were too long, so I dremel cut them to size, ut now they have completely flat ends. Think these flat ends are causing some...

FWB 800x, over time the 2.0 oz trigger was starting to feel heavy. The new setting of 1.7 feels better.