Recent content by Asher

Gk1 hands down. Any caliber is good

I'd get the Texan then. Have fun pulling out the arrows lol

How often do you intend to shoot arrows? Air bolts that must have their fletching twisted to go in the barrel will eventually need to be re-fletched. That's my understanding anyway. Dedicated arrow launchers, like my pioneer airbow, can in theory can be shot an infinite amount of times. I don't...

Theyre really incredible. On a hot summer day i once clocked a 41 grain slug from my .22 k1 (before i sold it) going 1094 fps. (108 FPE) Was a combo of a random fluke and that 1st shot regulator creep and the weather but the reading was correct, could tell by how much harder it hit. Recently I...

I should have but didn't. I just dumped the water, removed the case and mostly took apart the cylinder. It's tricky as there are 4 screws on the bottom part near the crank that need to be removed and are also tricky to line back up when re-assembling

Yes and I've had that issue with my power adjustment too. Kept increasing power until it was so high that it used too much air on one magazine and I didn't notice, and shot with not enough air causing a jam.

I have been filling my great white with my cs4 for quite a while now. It had started to make a different noise recently but still worked. I recently got a tube of the high temp food grade grease and decided to take it apart and clean it up. It was kinda gunked up, i apperantly put too much...

I do not believe that is correct. I've seen most of Gregor's videos on the gk1. The two screws are for trigger stages. What did happen to me though was I set my trigger fairly light. Then, after some number of shots at high power, (and therfore probably more vibration) the screw that sets the...

Somehow my gk1 barrel got damaged with ring shaped indentations in it, some of you may have seen my thread about it. I had to buy a new barrel and magazine setup from wolfiek. Trouble is, the new one doesn't fit .254 slugs, which is what i make and what my k1 rifle also shoots. I'm looking for...

Thanks, I already know how to do this. I do it a bit differently though. I put a slug into the magazine and push it into the barrel until only a mm or so of the slug is still in the magazine and most of it is in the barrel. Then I tighten the screws locking the barrel in position, remove the mag...

That's partly why I made this thread. Just got and polished the new barrel today. Unfortunately my fears that the new barrel and magazine would be unkind to .254 slugs proved to be the case so now I've ordered the .2513 and some .253 AVS to see which one works. Then I suppose I'll have to...

Just stopping in to say that i just got my new barrel to replace the one some of you may have seen my thread about. Anyway, before installing it, I polished it. After finishing, when I went to align the barrel and magazine using one of my .254 slugs, it quickly became clear that 254 is too big...

I also find it hard to believe especially since the fire cycle on hammerless AGs and the pressure spike happens so much faster than with many pcps that use a hammer and valve, but I really dont know how else they got there. Wish I could know for sure if any or all of them were there already to...

Hmm. Well some of the indentation rings are near the muzzle but some are near the breech end. There's 4 total i think

Looks very good. I did try 253sand they did ok but 254s were the clear winner. Mine is a v1, 5th one made though.