bchannell's latest activity

Beautiful guns. I had two 400s one old model and one new, wish I'd never sold them. Even tried to get one back😊 Honestly, I do like my...

I saw a news release where new stocks and upgrade parts were becoming available for the Avenger and some other airguns. My question...

You are correct, partially. You would have to check and see if it moves the reg enough to put the hole outside the two outer rings on...

Doesn't make any difference if you use the shorter plenum, the air pressure will push it down against the valve properly. Hole in the...

If you've reached your target velocity, the shot count and ex spread are the next concern, then accuracy.

I have to believe Hawke is right about most returns being overtightening. I know lots and lots of shooters and I would say easily 90% of...

No bids on HR bolt but I figured it out. Someone put too short a spring in and the ball wasn't doing anything. A longer spring and works...

One of my Snipers has a loose floppy bolt, and I'm trying to figure out if there's a way to tighten it up. I took the bolt handle off...

Ok, new day, new adventure. Set Huma @ 135 bar, hammer spring 1/2 turn out from max and results 16gr @ 825 fps, 7 es......go figure...

OD 9.3 mm Wire 1.27 mm Length 60 mm

I'm playing with my Cricket Carbine, and am getting some funny results Kalibrgun reg at factory setting, hammer at factory, which is...

I've probably posted this before, but my all time favorite air rifle is the Brocock Bantam Sniper. I've had a standard version, bought...

I have a nice Kalibrgun Cricket Carbine. Super accurate, and consistent. Just resealed and comes with several seal kits and a brand new...

Let's see, accuracy, even, magazine, even weight, advantage to Revere look & feel, Revere is a bit more svelt feeling trigger, Revere...

Resealed by Cricket and it was loaded with blue/green grrease both inside and action. Anyone know what that grease is? The pic shows...