Recent content by billygee

few more questions on the ID clearance between the barrel and shroud Just to clarify are both ends of the barrel 1/2 x 20 with the adaptor being 14 x 1 thread size ? with this having a 18.1" barrel, how much of it is screwed into the receiver ? Bill

Wanting to know how loud is the 10 shot Long Gun from Pinty Is it Back Yard Friendly or still need a Moderator on the end of it ? Bill

Looking Good ! was tempted but got their Bullpup instead , in question on the 11mm rail is it backyard friendly ? or still need a moderator for it ? Bill

Specs show regulators set @ 2600psi - 179.2bar and manometer luminate Did you have to disassemble to adj. the reg ? I believe one Spanish video stated it can be adj. by removing the manometer ?

Interested for a DIY having a Lyman 450 sizer or Lyman All-American Turret Press ? could some of those dies be adapted to fit ?

Hey Jim Appreciate your input, as for the gauged tube pressure, it's my understanding when a regulator is installed, it will change and only read plenum pressure. My question was adjustment changes to the regulator should it change bar gauge readings ? Building a better mouse trap may not...

Interesting Topic As said an interesting topic, even for myself an Old School retired mechanic (carb vintage era) no offense My understanding on a unregulated pcp, after a pellet, and desired pressure selection is made, a launched pellet tends to reach a certain flat level on the power...

Thank You Yes they do, and viewed it More interested on anyone on this site having any input after install.

Nice rifle to tinker or modify Considering installing a Lane Regulator Would like to know if anyone has installed one yet and their results or find after install Appreciate any input Bill

Thanks, Given an inquiry Bill

arrogance or jest

Have read an viewed a lot of Pro's an Con's on this rifle Yet, have not found anything on regulating it Has anyone attempted this. Mod ? Bill

Here's a little better understanding on this topic http://www.tacticoolproducts.com/bullethardness/

I myself have used that type of lead along with other's From what your seeking, it's difficult to determine without having some sort of test indicator There are a few inexpensive ways that can get you close For instance the lead pencil test If you Google that question, I believe you will...

Being a past powder burner using both sides of your interest There has to be another factor that has to be considered That is pressures acquired from a burner where gas checks and quenching would be an advantage Not saying it won't work, just have to go along with Roachcreek Dealing with...