CBHanlock's latest activity

Those are a pretty cool design. It shows you can make targets without access to a plasma cutter and welder. Thanks for sharing them with us.

I made a few of these back in early 2000s. Finally gave them away when I quit shooting field target. I used big Fender washers around...

Another note, the ring around the hole in the target and the trigger face are steel. Scrap from a clothes dryer if I recall...

See attached sketches for a better explanation. I will try to post a video later of operation. The springs are only needed when the...

i have a kit somewhere in my stuff but my point will be this has been done a dozen ways 1 Oring, 2 Oring, a solid head, full length...

We had 2240 based carbines in 177 and they reliably fell even at 50 yards with those little plinkers. On the other end, my s410 did not...

I got it now - thanks for the clarification.

The springs were a solution to terrain. If the target is placen on a hill, facing down hill, the front piece "hangs" down and you can...

Figure I would share my old knockdown target design. I made up a dozen of these a various critters years ago for me and my cousin to...

https://www.thingiverse.com/thing:5026987 There are a few things on that page. The only issue I had was the provided design is for...

Picked up this old American classic for 15 bucks the other day. Some fresh seals and a quick printed ldc and it is a great shooting...

Well I pulled my old disco out recently and decided to try adding a magazine to it. Unfortunately it seems the gravmags are nolonger...