Recent content by danny5692

I made this slim design. it's a lot stronger this way, doesn't touch the barrel and brings the bipod closer to the bottle. Printed with carbon petg. Pictures show the somewhat thicker first model. Drawing shows the end result. Yes it's strong enough.

Thanks for the advice. We have been using them for a week now without complaints. But I have made some from ASA too that looks really smooth too. Just need to keep the speed down for max result.

You dont know how to remove some tape?

I finally took some time to drawn and print a new cheekpiece. What do u guys think of it? It's attached with proper 3M self adhesive tape, so no screws needed. I printed it with a carbon filament

VERY, VERY nice shooting. Outside is always a lot more difficult compared to inside ranges. Excellent work.

I've replaced the valve two months after I got it.

one of the very first guns in europe.

I found the problem. They upgraded the seat. So it was a known problem at FX.

I have got some problems with my Panthera. It usually shoots like a charm but every now and then the valve seat keeps turning of place. Result is less power as the port is not in line anymore. I have tried other valve seats but that doesn't solve the problem. Does anybody else have this...

Hey that's mine. I designed and printed it ;)

I reccomend to lube that oring once every half year with one drop of silicon oil through the vent port with the gun pointed to the floor. Same goes for the other side on the valve cap, where the valve comes out. That will keep these orings in a good conditions. Especially when you fire rapidly...

accu tac fc4

It's almost May......is there anyone who owns a pro by now?

I'm sorry but that plenum looks way too big for that gun. There goes that sleek design... Next thing is a gauge on the side to tune that gun. Would be fair from FX to use the right pictures on their website.