Recent content by duchunter007

I get it, but when you are just punching holes in paper, it is nice to have a full mag, and when that is empty, I need to fill the gun again, I will not be using this when I am doing pest control.

I reached out to @ShootingNewB as they are making high capacity magazine for the Sniper XR in .22 cal. I asked if they were going to make them in .25 and they asked if I could send them dimensions for the .25 mag. This is the first one and it worked flawlessly. If you have a Sahara Sniper XR and...

Nice looking conversion!! I really like the .25 cal. as well

Great scopes and great value for the money!!

Just want to give a shout out to Shane in the service department and his team at AOA for the nice Power Tune they did on my .25 Cal XR Sniper HP. Shoots really good!

Funny that you ask, as I was expecting it to be firmer than it is, just a little more tension but still nice and smooth! I only shot it a few times and it was windy and heck and then started to rain looking, the wind stopped just long enough to get a quick sight-in and then I was able to shoot a...

With some help from @Sleeve28 I had been trying to tune my Sniper HR to get some more FPS and FT-LB out of it, I also had reached out to AOA to get advice from them as well. I managed to get it up to 901 FPS with 61.3 FT-LB with a 33.95 JSB pellet. I was also looking at maybe trading in the gun...

Love shooting my .25 cal. Ghost, lots of speed, and very accurate just spent the day shooting a couple of hundred 33.95 pellets, this was 931 FPS with 67.3 FT-LB on factory set regulator (155) and the power wheel on 14. Can not go wrong on buying one.

I agree with the Arken Scopes, I just bought my first one, the EPL4 in 6x24x50 and it is really nice! If you go to the Arken Optics site and decide on getting one type in Cyclops, and you will get a 25% discount

I have the MTC Rapier and I have to say it is fun to shoot when you get all the info and dial to what it is calling then hit the target you are shooting at :)

Looks like maybe you are missing a crush washer inside where the value screws into?????

Brocock Sniper Magnum and BRK Ghost bot in .25cal

Best to start low and keep coming up in 10 bar increments, and adjust the hammer spring as well

I have a Sniper Magnum in .25cal. I have been working on tuning mine as well, I would work with the hammer spring to help with the air leaving the barrel. You have to take the stock off to get the hammer spring and you need to remove the hammer spring as 2 lock screws are holding the hammer...