Hobbyman2007's latest activity

That's why I asked here and not at a local machine shop haha. Figured someone here would know how to go about it.

One more thing. Push a slug through the barrel and check for tight spots. Then inspect the slug, look for uneven rifling marks , lead...

Love that stock, looks great. I did have a condor branded 75 a few years ago. I let it go to a new owner after fixing the recoil system...

This is what I check when I have inconsistent values . Chrony, then hammer spring , then regulator pressure. If those check out. I move...

Are you sure the slugs you are shooting are sized for the barrel you have? That’s the tough part with slugs, .001” plus or minus in size...

While a "good" machine shop can "single point" the threads... You'd better make SURE...he knows what he's doing !! If the threads are...

Could be the fact that you have the depinger in there. It takes up space, not a whole lot, but it takes up space. When I put the...

Is it possible that the hammer spring has taken a set and is not hitting the valve as hard? From my reading the new V3 has a...

Any good machine shop should be able to do that. It’s going to cost you as shop rates have steadily increased over the last few years.

I was under the impression it was steel . Man that’s some anodizing . Any idea what grade aluminum? Now I need to find a shop that does...

Having never handled a RAW air rifle. The material used for the block, is it the same as the Theobens from back when they were blued...

Well designed magazine, unfortunately, at least for me, the JTS Airacuda MAX it came with was a dud. WM

It Amaze me the barrels LW will send out of the door, also amaze me the buyers of them have 0 entry check on them, or test of the final...

Thanks for measurements. That confirms it won’t fit.