HogKiller's latest activity

You guys are 'almost' wanting me to put my 5x-20x on my Raptor. I'm just too lazy to set up different range zeros, I've like got 4 that...

You might be better off asking this question to one of the 3 British pundits on the AGF UK. As far as I remember (as this was answered...

I'm not a fan of the chuck but if you checked the TIR of the chuck first with a ground dowel rod you should be 'ok'.

Ok ok, collets only from now on (or I'll crop the chuck outta the pic if I use it again:p )

Agreed, I'm a huge fan of chucking reamers also, if you have them, rigid is good, keeps the runout down.

Tapping with mill = great. Looking good. Holding endmill with chuck is a little dicey, collet is more rigid. Can't wait to see end...

After my recent horrible experience with FX Dreamline POI shift issues I decided to build a receiver which I could clamp in a bench...

Oh I agree, but it will displace water if you take it swimming, personally, I'd WD40 it then electro wash THEN Try-Flow, but then that's me.

Some people have rusty fingers, i.e. high acid or alkaline that doesn't help. Personally I like a light coat of almost any oil on a...

CLP leaves a film, comes in spray and bottles. I use it on all guns, knives and salt water fishing gear. It doesn't take much and you...

engineering, factory and facility, CAD's, Heating and cooling, computers, payroll and employee benefits pkgs, liability and real estate...

I'm inclined to give them a call and ASK how to take it off.

You are better off matching the washers in thickness so they all work equally, then polishing them a bit. Don't forget some real lube...

Ok so updated. Yesterday I took about an hour and a half polishing the brass piston, the reg housing, valve adjustment screw, and even...

Oh, I see what's they've done, there is a little plastic piston down in there, interesting, doesn't like like it'll deform like the...