HogKiller's latest activity

All airguns have their quirks, because FX sells a heck of a lot of guns more issues come to the surface. Mavericks aren't too bad to...

Normally I can knock off a reg in under 30 min, my friends took me close to 2 hrs because of that Y&^%$#@$%^&Y^%$ 0-ring down there...

This is what I came up with, YMMV. Please note that I said .35 but I've got a horrible issue with my memory and numbers, it could have...

ahhh the elusive chart, I'm sure they have it somewhere, I've found that a average .35mm thickness is about 110 bar to 140 bar, I like...

Brass picks, 0-ring, Amazon. A nice small dental pick will work down for that ^&%$#@ one that is buried but caution must be used.

I've been digging deeper into the FX Mavericks o-rings and I've found that there are serious errors in both the online schematic AND the...

Agreed, That is the worst one of the batch. A needle is the only way. I also have brass picks and reverse tweezers, they clamp when...

You can use a long needle to jut pierce it and get it started out of the groove and then fish a pick in behind it to get it pulled out...

I"m not reading the entire thread cuz I'm well not wasting my time, make sure your filter the living daylights out of the air to get the...

You sir, are officially screwed, you are jumping into the Rabbit Hole®, From here on you'll be making a choice of...

All I'm going to say to you comment is, when did this really start to speed up? No reply needed.

Momma gettin' a new coon skin coat for Christmas?

Find a large o-ring whose cross section is the same as the o.d. of that small o-ring & cut a thin slice to glue into the magazine. Been...

I know this doesn't answer your question, but Orion the Iguana Hunter Magazines doesn’t need o-rings to stay in the receiver...

Just to make sure, you're not using both the plastic seal and the x-ring? That x-ring must be thick! Your info all seems correct from...