iFish's latest activity

The Liqui-Moly arrived. But first, I heard from Umarrex. I responded and am waiting to hear back. I applied the Moly, basically...

Mine grabs a bit earlier than what I saw on yours. Regardless, for $12, it's worth a shot. I just ordered and it will arrive tomorrow...

Just another note, there is a bolt that screws into what we're calling the firing pin. If you place an allen key into that bolt, push...

I agree it's not the hammer or spring. Mine jams even when that is removed. It may have to do with the pins they use to hold the lever...

"when trying to cock 1/2 way through the cycle it started feeling gritty" "that little pin in the cocking lever works its way up and...

This. URL is time indexed to show brief explanation to show the step down device. Later a jump starter is shown, which may be the better...

A little cautious, sure. but not as elaborate as what; is shown in the image <grin> (That's a bit of overkill). I do use this though...

I have a CS4 and a 1.6 litre (100 cu inch) cf tank. It fills to 4500 psi. My CS4 handles it easily. Initial fill took a minute (I run...

You will always find a solution if you never stop looking.

Hi ifish, I have a pic to dovetail riser with 1 inch high scope rings so I have a good sight picture now. The scope came with med rings...

I think he's using low profile scope mounts. And, it's in the lower area of the scope view, so for me, I can deal with that. If you...

I think this may help Notos Bipod

Gorrila glue makes a black epoxy can use a fine tip paint brush to fill in the dent...but it probably won't match texture of the soft...

Hair dryer, on low at first. If that doesn't do it, crank it up. Heat will cause it to expand, and if you're lucky, expand enough to...

Yes it was. I found it 25 years ago, long before I got into PCP. It sat in my garage gathering dust. It was just the pump. I then...