jking's latest activity
jking replied to the thread Shattered by 250z Trigger: Can Someone Please Direct Me to the Nearest Exit?.I have no thoughts on that gun, but I think you'll get it sorted out eventually. I did however enjoy your writing skills. You may have a...- jking reacted to 1900colt's post in the thread How to cool a cs4 or cs4-i, even better than just bleeding the air pocket. with
Like. The water still exits the water pump to the cylinder head, from the head to the bottom of the radiator and out the top of the radiator... - Just my opinion but throw the krypton right out the window. It’s a rebranded tuxing twin cylinder. Not to say that is horrible but a...
- jking replied to the thread Feel sick and happy at the same time?.Every time we eat out, buy groceries, fill up the truck, dam near anything that involves forking over cash these days. I think I'd feel...
- jking replied to the thread FX Royale valve question.I had a 25cal Royale that had the smaller stem and valve. In a quest for more power, I installed the larger seat and stem plus some...
- jking replied to the thread FX Fx impact m4.I remember a couple of years ago when FX would watch the forum and address concerns just like this. Too bad they've lost this contact...
- jking replied to the thread Kral Arms Why did this take 9 years to think of?.I changed the AA T-bar on one of my AA for the convivence to fill like my other guns.... but I never had the T-bar thingy pop off and...
- jking replied to the thread N/A Regulator belleville stacking question.It adds additional stiffness at the same time. Just like if you removed one from #1 regulator stack (less tension), lower max pressure.
- jking replied to the thread FX O-rings for FX Regulator Adjust screw?.If you're going to order those you might as well get the others needed if you pull the regulator out for a rebuild. Very cheap and...
- 2mm x 1mm 90 duro, I get mine from O-rings and more
- jking replied to the thread FYI burnt cooling switch AV 4500.Thanks for sharing..
- jking replied to the thread Tuxing double cylinder - crank screw removal.You can also find a wood block or something similar to wedge between the crank and the housing as a backup when you want to loosen or...
- jking replied to the thread If you've ever wondered what a rattler with a pulsar thermion weighs in at....Isn't that about like a M1 Garand and I thought that was heavy?
- jking reacted to FLgunner's post in the thread What are your thoughts on 3d printed accessories? with Like. I think it depends on the part and the application. I have some 3d parts that work very well because they don't have to support a load...
- jking replied to the thread FX Impact M3 valve adjuster hitting barrel shroud.Back a couple of years ago they might have. Sure was nice to know that they occasionally did until numb nuts fudged it up.