Recent content by kevtan

Lets make 999 pieces of mixed internals and call them V1, V2 and V3. Lets mix it up some more with some regulated V3 and unregulated V3 and lets make them all at the same time! Lets put $50k in parts and juggle and see which parts get into what version of gun. And if they dont sell lets just sit...

Have you chronied the P3 after installation of the plenum extensions?

Rti P3 performance needs only regulated pressure for speed adjustment. The assisted valve uses air pressure to open and close the valve. Hammer spring tension does nothing but cause valve bounce. Adjust the hammer spring to open the valve only.

Mora as the P3 has an assisted opening valve. The valve open slightly via spring tension and is air assisted to open fully. Spring tension adjustment does nothing as you found out. Assisted valve are not the same as traditional valve in the FX or Brocock and most others. P3 does not have the...

Welcome to the rabbit hole. With pb you are restricted to the powder you can afford. Freedom comes when the power to propel the projectile comes with the cost of electricity!! Soon you will look for more expensive but not necessarily better airguns. Then you discover they also come in semi auto...

The black plastic piece is suppose to be the 6mm allen adjustment screw. Saw the thrust bearing in the previous pic that was suppose to be between the adjustment screw and the base of the belville springs. Does the black plastic piece have a hex cutout in the hole side? If it does then just...

Sounds like you have P3 and am dissatisfied with it. Care to elaborate?

Can you take a pic of all the parts of the regulator?

That black plastic in the hex screw hole hides another allen hex screw that adjusts the pressure. You could have been sent a sample non adjustable regulator. Suggest you talk to ROK. He might ask you to drill a small hole in the center of the black plastic piece and pry it out to access the...

P2 and P3 have the screw caps that can be changed to extra plenum space, 1 of 22cc for P1 and 2 for P3.

Or cast and size them yourself with this mold https://www.mp-molds.com/product/642-mm-air-pellet-8-cavity-mold-version-3/ As tested by Gregor here for the .22 for the .25

Cant find a Lane regulator for Huben but Huma has.

Advantage of Lane regulator is the consistency with no creep. But its not a direct replacement since its not externally adjustable. Lane regulators in the K1 can only be adjusted with it exposed. Huben had problems with consistent regulators up until 2020. After that the regulators are good once...

In. Thanks

I know you……. 😜 Freedom 1 does it as well.