Recent content by LRP

Found at the webside from Huma Air

You can see a carbon barrel stiffener, which puts the barrel under tensile stress and thus stiffens it

Update

Update.....Here is my attempt to pre-tension the barrel with a carbon sleeve that will come tomorrow. The thrust bearings are already finished.

The background of my work is that everything remains mobile without much effort. The large separator is also only used for bottles, so it is not mounted directly on the compressor. Unfortunately, most conversions are often pure handicrafts, which exclude any mobility, ...... neither compact or...

Singleloader made in black POMloader

This is my final product. When I fill bottles, I use the separate oil/water separator. I didn't mount it on the compressor to keep everything mobile. The VEVOR sheet metal housing is more suitable for cooling the oil.... YongHeng has installed better high-pressure valves.....so I make a clone...

Thanks my frind!

My modified original AEA silencer (complete interior and exterior new) is a gain for my 50 Cal. The original one only works as an absorber and is extremely loud with my revised Challenger, now with chambers and jacket outlets..... it`s ok. Bigger Cal. more Problems:D

Update: I made a new inner life for the original AEA silencer. I hope it works better. The inner Diameter is now 14.5 mm against the ori 16.0mm. diameter is. I hope I can test it tomorrow and make a video.

Yes.

The material is the same on some compressors. The brown rings for the 2, Stage. I dont ask for spareparts...i ask for the type of material.

Normally I zero at the point where the projectile, with my force settings, goes above and below the laser line of the scope. Not somewhere you want to go. Before that, I set my scope mount and the turret to zero.

Any inert mass can stop projectiles. Sand... Rubber mulch or liquids. The decisive factor is what is well applicable in a bullet trap. I think Rubber mulch is the best.

Does anyone know what material the brown high-pressure sealing rings are made of? Delrin or Teflon or another plastic? Since spare parts are often not available, or with a waiting time, I want to make my own in stock. I think white Teflon is too soft. The brown plastic feels harder when it comes...