MartinT's latest activity

I made this slim design. it's a lot stronger this way, doesn't touch the barrel and brings the bipod closer to the bottle. Printed with...

Anybody know why the CPHP .22s are (due) out of stock every where? (well Amazon still has them, but none of the ususal suspects...)

The very best portable bench and even for a permanent setup is https://www.stukeysbenches.com/. They are also the most expensive. When I...

Nope, I exchanged it for another. The new one is working fine.

I was able to get it fixed up.. thank you.

A 90-shore, 13mm inner diameter and 2,5mm thickness should do the trick. Thanks to @MartinT who did the homework.

Nice find! Too bad it looks so ’clumsy’. I’d have preferred an FX Maverick type sidelever… (but maybe when anodised in black it looks...

I used a dovetail to picatinny on the pp750 and picatinny riser on the Notos. Haven't had poi shift with the Notos. Riser was needed to...

Pairing the DNT Zulus/Thermnight with a Notos is a bit of a PITA for 2 (or 3 if using aftermarket magazines) reasons: First: The small...

So, all sorted out?

Yes, thank you, Black Betty is up and running again!

Ok, so I just gave it another try, and it finally gave way! Now let’s find a new fitting O ring!

I have a fix! Turn the sear face square, heat until a dull red glow, dunk in used motor oil. I've seen three dead-soft hammers over...

Does the trigger (pull weight) vary by every couple of shots? If so, this is most likely due to a rotating hammerweight (which is held...