Mike_Lenardon's latest activity

30cal 19" barrel doing 94fpe with FX Hybrids for coyotes.

I decided to replace the grease pot diaphragm in my CS4-i, because I was finding it inside of the greasepot all folded up and wrinkley...

Cut the front off the fill assembly. Used Birchwood Casey Aluminum Black to refinish. Then drilled and tapped for 1/8 BSPT. NO MORE PROBES

In fact I had a notos with a 380mm superior, from 730fps to 840 they shot well enough to take 100s of souls. After I slapped on a...

In the sense that it is a light gun which makes it harder to shoot than a heavier gun.

There is always a fair bit of moaning and groaning when i have been down low, fortunately getting out of bed is still a breeze...

Right there with ya,,,,stuck on the floor

Yea once you figure it out it's not bad...getting up is the hard part 😂

@Kdog , I could do the kneeling thing too but then I have to figure out how to get back up :eek:

I can only get 11yds inside but offhand and kneeling is great practice. Been doing this the last 2 mths. Just getting comfortable with...

This is the video I found for some at home solutions. The bottle brush seems to take the least volume of air. It works excellent, it’s...

The bottle brush depinger was all the rage back on notwork54. Only problem I remember are loose bristles floating around in the tube and...

Yes the screw is located under the bolt instead of were the pellet loads. This will work on the Discovery as well as 2240, 2250 and 2260...

If one can ignore the leadership then California does have some good points. It was sunny and 63 yesterday.

I feel ya. I'm in NE ohio and can't wait for the weather to break. It's about 9 this morning.