Recent content by MikeyJ

👍🏻thanks!

Cool! Will this be on your website at some point?

Hi folks, Is there an o-ring kit you would recommend that would be good for GX compressors, specifically the CS3? I have to replace the little o-ring inside the bleed valve assembly on the CS3. I can’t measure it due to its condition (does anyone know what size it is?). Anyway, I thought it...

👍🏻Thanks!!

Not that one! 😉 Thank you!

Thanks! Problem solved! At least for now. I removed the nut. On the back end of it (behind the little steel ball) is a valve with an o-ring. I cleaned all those pieces, regreased the valve and o-ring, flipped the o-ring over, and reinstalled. No more leaking. 😁

I hooked up to a gun, made up a better leak detection solution, and I think I may have found the leak. It seems to be at the bleed valve connection. See photo… the bubbles appear to be coming out of the bleed valve port even though I have the screw well tightened. But there are also bubbles...

I hear ya. I’ll keep investigating leaks and try not to stress about it. Thanks!

I didn’t even get to the point of using it with a gun. I was just testing it out of the box.

Thanks. I’ve tried that, but can’t see any leaks. I have to figure out how to get to the underside of the pressure gage. Everything else is tight.

Hi folks, I recently bought a new GX-CS3i compressor on Amazon. I did some deadhead pressure testing and noticed that the pressure dropped immediately after hitting the set psi level, even though I hadn’t yet opened the bleed valve. I checked for air leaks but couldn’t find any. Not wanting...

Hi folks, I have a PCP Kong Lil Foot (version 1) on which I’d like to put an hour meter. I don’t want to go the vibration sensing route. Instead I’d like to hardwire one. My compressor is the type that has the converter inside the case. Where exactly do I connect the wires from the meter? Do...

I recently bought the same rifle, but a custom tuned version from AirGun Revisions. I've been using the 18.13 grain JSB Exact Jumbo Heavy (my go to pellet), JSB Exact Heavy 15.89 grain, and JSB Hades 15.9 grain. They're all good, but my most consistent shots are with the 18.1s and the Hades.

Thank you! Great, thank you!

I purchased a 1/2-20 DonnyFL adapter for my Benjamin Marauder rifle. The adapter does not have an o-ring on it, but the end cap of the Marauder does. Do I need to transfer that o-ring to the adapter? If I do, the adapter does not tighten flush to the barrel shroud - the o-ring doesn’t go all...