MrP's latest activity
The attached video shows the progress of the project. Unfortunately I am lat on it, because I was using 3D print metal parts for the...- Just received it a very short time ago. This thing is HEAVY DUTY, belt is nice and wide with suede lining so it doesn't slip. The...
- MrP replied to the thread N/A Best value PCP?.pp700 bears mention. It's one of the guns where the barrel is threaded into the receiver. Externally adjustable regulator and hammer...
- Primary objective being value, yes, the Taipan Veteran. One of few airguns, at any price, that has a barrel threaded into the...
- MrP replied to the thread Ordering from Krale - address format not correct?.I'm glad some of you all have received stuff boxed properly from Krale, so have I. the point of my comment wasn't to criticize the...
- MrP replied to the thread Ordering from Krale - address format not correct?.I had the same problem, was not able to resolve the issue with the form so I left a note in the comment section showing the correct...
- MrP replied to the thread Which mould for casting slugs for the Huben GK1 .25(3)?.Glad to see people casting with this mold for the GK one, I've been curious what other peoples results would be
- MrP reacted to Ydunn.223's post in the thread Which mould for casting slugs for the Huben GK1 .25(3)? with
Like. Another good lead to try would be some 30:1 from Rotometals or like the 40:1 will have a BHN of 7 and will fill out very nicely. I did... - MrP reacted to Wofys World's post in the thread Which mould for casting slugs for the Huben GK1 .25(3)? with Like. Update: I cast slugs using 25% RO's hardball and 75% lead. Tested today and seems to work well in both the K1 and GK1 .25 caliber. Hits...
- MrP reacted to Wofys World's post in the thread Which mould for casting slugs for the Huben GK1 .25(3)? with Like. Update: I recast slugs using 25% RO's hardball and 75% pure lead. Tested today and seems to work well in both the K1 and GK1 .25...
- MrP reacted to Wofys World's post in the thread Which mould for casting slugs for the Huben GK1 .25(3)? with Like. I have the Huben .25 K1 that I plan to cast some slugs. I just ordered the MP Mold and sizing die set for the .254 size. Anyone have a...
- MrP reacted to grouch-o's post in the thread Which mould for casting slugs for the Huben GK1 .25(3)? with Like. finally ordered them in the current price reduced phase. thanks again for the hint, much appreciated.
- MrP reacted to RNT572's post in the thread Which mould for casting slugs for the Huben GK1 .25(3)? with Like. I’ll give a plus one on the Bob’s Boat Tails from NOE. I have the 250-51-FN which I picked up on a group buy a number of years ago. NOE...
- I dont have a .50 BMG so i could probably get by with rings made from a good hard wood.
- MrP replied to the thread Huben Gk1 .25 vs bintac t9.GK 1 sure is squeezing a lot out of that 25 caliber barrel