Mycapt65's latest activity

That's beautiful. I wonder if they'd make it with a low comb and less pronounced cheek piece?

A couple of more pictures. The stippling is very nice.

Oh, the bureaucracy is insane. On top of that, if your shipment runs in to an activist anywhere along the shipment process your stock...

I also ordered one. I have a thumbhole from them for a HW95. It's a beautiful stock, but I was a bit disappointed due to the lack a...

Hey if anyone here does get a CS stock made for their 30 or R7, please contact me if you'd like to sell your old one. I'd like to lower...

That's a logical answer. There's a few trains of thought on this. On synthetic sealed springers very little lube is needed. Any...

Yes that's the correct size. But who manufactured the seal?

I don't worry about checkering at all. If it gets sanded a little no problem because I chase it all out with needle files I heated and...

I refinished a couple of stocks on Beeman guns from the '80's. After paint remover wouldn't get any more of the color out I used a...

Here is an R1 I refinished using MinWax Poly Shade stain/finish and TruOil. I wish I could remember if I sealed the wood first or not...

There is a lot involved to get an “old world” look on a Beechwood stock. Here is the step by step. 1. With a chemical paint and varnish...

Dont use oil in a springer. It will diesel and burn the piston seal

Length isn't that important. Longer springs can be made of thinner wire and be weaker than shorter springs. Measure the outside diameter...

Here are the 2 bench's that I built, had the room so the tops are 48x48x3/4 ply. The bench top is big enough to set all your support...

It will make more power with 8.44s . Did you change the piston seal? Who knows what it should do with a different spring?