Recent content by pcpSWE

It was a blown o-ring on the regulator. The OEM schim stack for the washers where can it be found? I followed a YT guide for different gun but I am not sure what up and down on the washers is.

FPS on my gun slowly went down from 930fps to 830 over 200 shots. I started adjusting the pressure and then released the air pressure to remove the bottle. At that point, an o-ring on the adjuster valve broke. The gun is just a few months old and has less than 1000 shots. Replaced it but it is...

I would like to have the Zulus with a quick connect mount. I want it handheld until I have found the target. Does at 0 Moa mount with quick connect exist? Something like this

Ok, did not know that. Thanks. So the 0 Moa is the way to go?

35 Moa long is the mount I should get for my FX crown mk2 if I understood correct?

Pellet port yes transfer port on max. Check 🙂 What numbers should I excpect? I hear 110bar and speed in the 900fps. Then I read some that are at 150bar and shooting 870fps. Jsb 15.89 is what I was recomended and shooting in my gun. What fps should I aim for?

Is it this one you are asking for? https://www.airgundepot.com/fx-crown.html

Help me understand. I started out with 95bar. I follow the instructions as I understand. 2 turns clockwise as shown in the picture above at a time to increase hammer spring tension right? But after doing this 2 turns at a time, steady increasing velocities it stops, I increase regulator...

I have watched it, and I understand more, but it is difficult without seeing the adjustments he is doing. I found this text and picture helpful in getting it visual. Turn the Allen key down = clockwise = increase hammer spring tension

Hs15, how did you zero your hammerspring before adjusting?

At 8.00 in this video is this a correct way to zero the hammerspring adjustment?

It is a unlimited version. And tightening the hammer slider screw is to screw it in right?

Wow, what guide can you recomended me to follow for hammerspring reset and adjustments? I am lost now.

Still no speed. Any tuning guide that you can recomend for initial adjustments for a noob? 150bar, Max hammerspring

The dumbass at least found the problem on my own :ROFLMAO: I removed the adjuster wheel at some point and forgot to think when I reassembled it.