Recent content by Pea-shooter O.G.

I recently took a chance and found a lightly used Creedmoor Hardback in my size on Fleabay. Like stated above, it's well made and heavy. Thankfully, it does not smell like AirNGasman! I haven't had alot of time to shoot in it, but shooting knees up and forearm of gun on forearm, it takes alot...

Yep, they need the Creedmoor Hardback with THE EXTRA SLEEVE STRAPS THAT WRAP THE ARMS ACROSS THE CHEST!

I'll show some HW44 love! I purchased this near new gun recently from an AGN member. I reduced power and get 30 shots on a fill, shooting JSB 10.3s at 695fps. It parks pellets on top of each other if YOU'RE steady enough. Standard 10 shot group below at 25 yards from bucket and trigger sticks.

Hey Mister Bill, one thing you may want to consider is adding a dovetail to picatinny rail adapter that has some elevation compensation built into it. I only say this as most Diana I have require this type of mount because of "barrel droop". What happens WITHOUT the compensation is, you will not...

Awesome! How was the report after shortening it? I'm considering shortening mine for pistol field target as well.

I was curious if you were successful in shortening your moderator. And if so, how did you do it

This listing has been renewed

Like Motorhead suggested, I did something similar by finding an Oring that fit in the hub of the scope wheel to act as a spacer.

Thanks Joe! I had asked RAW if the 12fpe was able to be adjusted with a spring change up to 20fpe and I was told the internals were different enough and I should buy the guns in both 12 and 20fpe. While that might be the case, it's good to know it CAN be done with a hammer spring swap from 20 to...

Scott has seen the way you look at that gun, there's no way he'll let you touch it!🤣🤣🤣

I really like your setup Did! Did you get the 20fpe gun or the 12fpe?

This listing has been renewed

This listing has been renewed

I'm looking for a right hand Field Target stock for my TX200 HC. Let me know if you have one you're not using Thanks, Jason

I wanted to follow up on my TX200HC. I installed the 12 FPE Vortek spring kit and piston seal. It was shooting about 13.5 fpe, so I shot a few hundred rounds to get the spring settled then cut the spring until I hit the 12 fpe mark. I needed to remove about 2 coils. Its so much nicer to shoot...