Recent content by Privateer

This listing has been renewed

Hatsan Jet magazines will fit the Streamline. Only 6 rounds in .25 but real reasonably priced.

The fill assembly from a Max Air.

Love that Donner Party butt stock! :ROFLMAO:

Used on the DreamLite and Tactical versions. Part number 20021

Just resealed StreamLine with Huma Regulator and hardened Valve seat. Comes with another Seal kit and original Regulator. $450 + shipping.

Sadly that PDF only gives you an idea of what a regulator is 'kind of' set at by color code on the regulator. You can get some information from this video https://www.airgun101.com/fx-airguns/video/fx-masterclass-regulator-maintenance-amp-rebuild I'd love to have that Regulator tester as the...

This listing has been renewed

It's on FX web sight. https://fxairguns.com/wp-content/uploads/2021/04/regulator-pressure-chart.pdf

I did a slight bevel with a 135 Degree drill bit then polished with 400 grit sand paper. O-ring pressed into place much better it seems. Made a new delrin seal also. So far it's not leaking from the bleed hole and is holding air at 150 bar. Will check the pressure again tomorrow.

This listing has been renewed

Only direction now is straight down the Rabbit Hole! Once you mention FX? Your Doomed.

Man after my own thoughts! (y) Looking real close at the design and that failed o-ring near the belleville washers? I'm thinking that was my 1 PSI per minute leak. I'm going to see if I can cut a slight bevel inside the Regulator body in that area. What I see is no bevel or a rough bevel?

Here's a DAR Gen 2 regulator taken apart. The black section is only the carrier for the regulator in the air tube. I've beveled that as you can see to make it easier to press the Regulator back into it and not sheer the o-rings. One thing I don't like. The Delrin seal (white disk) is 1 mm...

Do you have the dimensions of the Gen 3 reg Huma makes? Wondering if they are the same as the Gen 2.