Ranchibi's latest activity

Ah yes, .219 heads being sent through choked barrels (LW polygonal and FX). A good lapping regimen (cast lead lap with an aggressive...

It’s very interesting that this pops up. For the last couple days I’ve been shooting JTS pellets out of a gun trying to find a setting...

No amount of washing or lubing those pellets is going to help you. They have a head size of .219 and a skirt size of .224

You can get a side shot and use your cell phone. Most cell phones today can take great video ...

I have good luck with the Pard NV008. Attached is an example of how well it works inside barns as well as outside.

Dillon! That tiny Discovery 2-12x24 looks perfect on it! Pests are in deep terminal...😂👍

Put the 2-12 Discovery on it as the Arken was just too big. For my compact lightweight guns these scopes are hard to beat.

Well...That one didn't last long...Checked at 7:30edt...gone...Would have gone well with my standard Mutant...there has/is some good...

Dairy boy that Mutant is old news , Dont waste your time on it , Just pass it on to me 500.00 and get you a new gun,,,, Mike PM me for...

I have my PCP's zeroed @ 20yds @ sea level but pest for ground squirrels @:4500ft elevation so my POI changes but I use a ballistic app...

I try to setup a trajectory with a one inch kill zone out to about 40 yards then I don't have to worry much about hold over except at...

Hopefully sooner rather than later. 🥲

Air is not air as the Density changes and temperature changes with elevation. Do to the steel tank the pressure change won't effect it...

Mechanically / Pneumatically a Non issue ;) Flatness of the shot gets a lot better as the projectiles BC value increases with altitude...

Going up in elevation might affect the pressure in the tank, just a “tad”, because of the less atmosphere pressure on the reservoir, but...