Recent content by rdpjr6504

Try using hair dryer or heat gun to heat it a little and should come off.

Hello my Avenger end cap unscrews. If it is an Avenger X I do not have one yet so can not answer that.

My Hammer had a leak that I took apart and replaced lower seal on reg. When I reassembled and lined up fill port and gage the tank had a wobble to it. After filling the wobble was gone. Hope this helps.

Mine is a 250cc also.

Looks nice. Your tank looks longer than mine. I asked if there was a longer tank and was told it was alot longer. What is the length of your rear tank tube ?

Thank you. I was able to disassemble- very easy to do- and found previous owner drilled transfer port path and valve and valve is trash. I bought it several years ago and did shoot it 2 times but transfer hole in valve being drilled removed the edge where o ring sits. Now to find a valve.

Hello have an ATAMAN M2R BULLPUP in .357. Has been in a case for 4-5 years and has leaked all air out. Tried to fill but air blows out barrel. Even cocked rifle first and used scuba tank with 3000 psi burst with no luck. Anyone know where to get a disassembly diagram or video that will help ...

The rear tank is 300cc not 180 cc from the pellet shop. The pellet shop said I should get 2 extra shots with the rear tank. We shall see this weekend.

It is the .457 and I have only shot it a couple times. On the first shot it is loud and dumps 1200-1500 psi air. Found the poppet return spring was weak. Contacted BINTAC who was going to send me a spring but never did. I inserted a 1/8 spacer under spring and seems to empty about 500 psi per...

I have it on all the way and LOP is 13 1/2 inches. You can loosen set screws and get another 1 to 1 1/2 inch if needed.

Hello have an AEA ELEMENT MAX with the add on rear tank and did not like the stock it came with. Found a gentleman on EBAY under Proof1447 who was kind enough to make a larger one than what he was selling for me. I think it makes the rifle look and shoulder better What do you think ? 1st image...

Something like the BARRA 250Z with side lever and .30 caliber.

Hello I purchased the Hammer from birdie and installed a new gauge. It was a 10mm.

THAMMER is the best. He did his magic on my sear and middle piece that pushes on the sear. Both were smooth and it now has a trigger that is buttery smooth. It will make it a pleasure to shot.

This listing has been renewed