Recent content by remarkablemagic

Oops replied to self accidentally.... Sounds like what I found. How can this happen and what can be done to avoid and or fix it?

Sounds like what I found. How can this happen and what can be done to avoid and or fix it?

OK, I managed to free the hammer by removing the hammer spring and easing it back to fully cocked, replacing hammer spring, while at full cock and tension and replacing the end cap screws while holding that end cap in place against the spring tension (easier than you'd think). I was then able to...

The hammer is jammed part way forward. I took grips and back off, no obvious way to free anything, just jammed like it was glued together.

From now on, only Crosman or Pyramyd Air. This was a legit, bubble packed 1322. I have a couple planned orders for Pyramid; picking up a 2240 and cheap C11 bb plinker and new Ammo for replacement 1322 and the 2240. I will soon order from the custom shop direct from Crosman, but I wanted a...

Amazon is replacing it. I'm very displeased though, as I'd heard they were quite reliable. The piston from the back is jammed forward, preventing full bolt travel. There should be no foreign matter; it been in it's holster that I custom made for it.

Model in thread topic, had you read it. Storing a gun unloaded leaves you with a bludgeon. I'm sure that topic is debatable and not germane to the point..

Maybe I was wrong to do so, but I have been storing it loaded and pumped on safe. I was told these guns last longer stored pumped. Worked flawlessly for two weeks, shooting it daily. Then one time it wouldn't fire. Managed to re-cock it, get pellet out, dry fired to release air. Worked fine...