Ries's latest activity

You need it. I have it on my Impact and Wildcat. The dual port from FX is too small, in combination with a pin probe I gained 20 fps...

I too made this mistake the first time and it made for an odd feeling and violent shot sequence.

Remove the hammer spring from Huma. That is too much. I tried it aswell, lightest Huma hammer and Huma spring and I was not able to...

A friend of mine and I experienced issues with the stock hammer in a .22 cal 700mm FX Impact. Above 120 bar, it struggled to open the...

Glad you solved it! Enjoy shooting again.

Found the problem. I turned the adjustment screw behind the trigger all the way closed. After that it had enough air for a few shoots...

In recent couple years the JSB MRD's accuracy fall apart. With my Impact MK2 I can get them group in a 1 MOA @ 50 all the way up to...

Not an FX but my RW NEEDS the pellet going 970+ to get good accuracy at 100 and I've taken out to nearly 300 yards with good accuracy...

My Impact for benchrest at the shooting range is tuned around 960 FPS with redesign pellets. I cannot complain about accuracy. I have...

Redesign pellets are not 100 yard pellets if im not mistaken.

Sounds like your regulator is backed out all of way.

If your bottle is attached and filled with air, but the second regulator gauge isn't showing any pressure, I would check the regulator...

You mean the second regulator gauge? The gauge where the magazine sits

No worries, I've updated my post with an additional check. These would be the first two things I’d check. If the transfer port O-ring...

Check your valverod oring. Its a tiny one. O-ring 2,2x1 NBR 70 I've already replaced the O-ring twice in my Impact, and you can...