Recent content by RTI Arms

Unfortunately yes...

Majority of UK guns are sub 12, yes. We will try to visit UK dealer for a training soon.

I agree, it never should be. But I cannot come and bring a new one, nor can you send it back to us. Unfortunately it needs to be communicated thru the dealer. I do not know how smooth that communication was. I was just notified that the barrel was changed.

That is correct. I cannot talk about the restrictions here due to obvious reasons... But I think it is clear anyway.

We wish to get the gun back to take a look, but unfortunately that is not possible due to being outside EU, so the dealer is stepping in. We also hope we will get the barrel which you returned to take a look. That would make it the first bad barrel after few thousands, but it is, of course...

We have changed the knob. Hand turning knob was OK if you used lower pressure, at higher pressures you could not turn it... So hence the change...

Would free hat work?

I think you need to look again...................................

Check out the renewed rtiarms.eu website. Let us know if you like it.

Check out the renewed rtiarms.eu website. Let us know if you like it.

You can change the length of pull by turning the trigger block around. But you need to disassemble the front and upper...

I just checked emails and I don't have any Simon, except one from New Zealand. Are you sure you were talking to us? It is possible we missed it, but we do try to answer most. Unfortunately it is possible that it worked when we were shooting it. We do shoot each one for accuracy and also before...

I apologise for a late reply. We have plans on doing a video about it. A drop or two every 500 or 1000 shots is fine. Everything is better than nothing!

The connecting pipe should not be the issue, it should pass air thru in any position allowed by the assembly. I hope it stays filled...

The easiest way is to open the dwell time and hammer spring to max and then find your velocity with pressure (go a bit over your desired velocity). Then you need to adjust the dwell and spring tension. With spring tension it is easy, go down until the valve does not open anymore, then return...