SLICKNICK's latest activity

I’d like to give a shout out to Molly’s Lead Shed. My most accurate slugs were Boat tails from ProSlugs that closed that business...

The shims go against reg. That’s not the piston from hammer. But it’s a similar regulator

@thammer and @SLICKNICK Thank you both. There is some good information here with photos!

One more trick. If you want less than 2 moa at 100yds. Use the same magazine slot for the entire shot string. Some strings will be less...

That’s a shot string from a 380Gr boat tail slug. That by the way are by far my most accurate slugs. specially for long distances

Mine is set at about 3400 PSI. If I remember correctly. I may do a reg cleaning this week, and I’ll verify my output pressure if you...

You can control pressure with shims. It’s roughly around 200psi per shim. I put mine on a gauge, and stock does not output 3000 psi. You...

I had a small leak that I figured out was the small seal on the top of piston was worn. It happened after about 1200 rounds. You can see...

That’s what my reg spring looks. And that’s how many, and the shims that are in mine now

No, those are the spring shims. They need to go back how they were

https://www.ebay.com/itm/126558162005?mkcid=16&mkevt=1&mkrid=711-127632-2357-0&ssspo=Sb_Au1P_TRu&sssrc=4429486&ssuid=o21_jLcHQAO&var=&wid...

I lied....I only have one. Either way shoot a DM.

Power can be adjusted on the hammer. You have to take bonnet off regulator and add or subtract shims. No shims, it shoots with less...

All proslug’s slugs should be available at Molly’s lead shed in a month or so. They purchased John’s equipment ✌️