steve-l's latest activity
- Ssteve-l replied to the thread N/A Cheapest accurate, reliable, cocking, .22 pistol with red dot or other optic?.There is only one gun that fits your requirement. That is the PP700SA. in .22 I have two of them. They are about $250 new. They shoot...
- Ssteve-l replied to the thread Huben GK1: What Silencer for Backyard Quiet? (or almost).I have said this before , but I will repeat myself again. 3D printed moderators do not have adequate strength or dimensional accuracy...
- Ssteve-l replied to the thread FX Superior Heavy or FX Superior Slug barrels. What is the difference?.I prefer the 1:18 barrel because it shoots both slugs and the 34 gr JSB pellet very accurately. I rarely use slugs as they are too...
- Ssteve-l replied to the thread Huben Contemplating the Huben GK1, questions....I have a V1 and a V3. I have never had an air dump, but then I follow the guide lines. If the instructions say don't fire if tank...
- Ssteve-l replied to the thread Looking for a Neighborhood friendly Silencer for the Huben GK1 .25.Accuracy issues with the use of moderators on GK1s can exist because the moderator adapters also clamp the shroud to the frame. If the...
- Ssteve-l replied to the thread Looking for a Neighborhood friendly Silencer for the Huben GK1 .25.Yes, you can silence a .25 for backyard use, but you do not need to shoot with energy levels higher than say about 40 lbs. If you adjust...
- SI think you are better off with a short microbore whip with quick disconnects at 1/3 the cost and is going to last you a lot longer...
- Ssteve-l replied to the thread Huben GK1 .22 recommended pellets for lower power (UK Sub6).Your experience is not mine. Out of curiosity, please measure your magazine's bore size with pin gauges (go/no go) and report back here...
- Ssteve-l replied to the thread Kral Arms Kral parts in stock (at last) at Bagnall Kirkwood - UK.Just as a note Kral, as a company, is terrible about supporting their guns. Parts and service is essentially with them. non-existent...
- Ssteve-l replied to the thread EaZy Trigger Fill for PCPs.It is a great idea, if it works and it fails with pressures exceeding 200 bar. I have bought 3 and every one failed.
- SI finally broke down and bought one last year. I'll endorse it because it does save a lot of waisted air and is a great concept making...
- Ssteve-l replied to the thread Why El Cheapo compressors are no bargain.As I have said many times before in other threads, HPA is expensive no matter how you get it. You can solve the excess heat problem of...
- Ssteve-l replied to the thread Why El Cheapo compressors are no bargain.That's a difficult question to answer. It depends on where you look, its condition and to a large extent how skilled you are in...
- Ssteve-l replied to the thread Why El Cheapo compressors are no bargain.At the end of the day, you get what you pay for. If you use these cheap compressors to only fill the guns directly., the design duty...
- Ssteve-l replied to the thread Why El Cheapo compressors are no bargain.All you nay sayers will eventually agree with me that these cheap compressors are a bad investment once you have been in this hobby long...
