Ta-Ta Toothie's latest activity
Ta-Ta Toothie reacted to kwaping's post in the thread Introducing the Daystate Black Wolf! with
Like. I went to Airguns of Arizona today and put my hands on their floor models. I also had a great chat with Chris J about the Black Wolf vs...- Ta-Ta Toothie replied to the thread GX cs4 cs4-i duty cycle update from Manufacturer.They must be getting warranty claims with everyone filling large tanks.
- Ta-Ta Toothie reacted to 1900colt's post in the thread GX cs4 cs4-i duty cycle update from Manufacturer with Like. Ad just updated tonight, recommended by the factory.
- Just a little update for run time I noticed from the tuning I've been doing over that last several weeks. The "GX CS4 Internal" now has...
- Ta-Ta Toothie replied to the thread A New Wolf Rises.Maybe due to the oil and sweat from our faces.
- Here is a cheat sheet:
- This is my homemade stock that I made for a Raw TM1000 that I purchased as a lefty, knowing full well that I am a righty. It took me 4...
- This is the way I see it: for all those people who didn’t like or dislike the electronic (computer) in the airguns Theirs wishes came...
- Ta-Ta Toothie reacted to Amwolf's post in the thread FX What happens if you shoot an FX with the tank pressure below the regulator pressure? with Like. Ok, so its the airgun equivalent of not dry firing a .22 to avoid damage to the firing pin. Am I right that the system is designed so...
- Ta-Ta Toothie replied to the thread FX What happens if you shoot an FX with the tank pressure below the regulator pressure?.If you got the AMP reg, just back off the srew once the bottle is removed.
- Ta-Ta Toothie replied to the thread FX What happens if you shoot an FX with the tank pressure below the regulator pressure?.Yup, a while back when I installed my HUMA reg and couldn't degass it with the screw, I asked HUMA how to proceed, they said shoot it...
- Ta-Ta Toothie reacted to 1900colt's post in the thread Grease for GX compressor gear drive with Like. How many failures have you seen? I'm aware of three cs2 with teeth broke off (usually a case of starting under pressure) one cs2 that...
- Ta-Ta Toothie replied to the thread FX What happens if you shoot an FX with the tank pressure below the regulator pressure?.Shooting 5 bar below won't cause a problem, just don't go to the extreme. Don't degass the gun by shooting it down even with your hammer...
- Ta-Ta Toothie replied to the thread FX What happens if you shoot an FX with the tank pressure below the regulator pressure?.If your lucky and have the valve locked open, you can just push the stem back in to reset it. Have any doubts, buy one and try it out...
- Ta-Ta Toothie replied to the thread FX What happens if you shoot an FX with the tank pressure below the regulator pressure?.Worst case scenario, you can damage the valve, seals ot knock the seat out of place.