xring308's latest activity

I actually have a 3D printed tray but haven't used it lately. Will definitely use that for my troubleshooting work here. Thank you!

@xring308 - Have you tried a different magazine or single shot tray? My friend really likes the 3d printed shot tray for his marauder.

Thank you for the input. There's definitely enough concern here on magazines to prompt me to clean and check all three of my mags. I...

I had a magazine that was not rotating to the center of the barrel and would throw a flier randomly. I cleaned the mag with some...

Will definitely try it single shot and check my mags closely. I'll also check the hammer/travel and make sure all is OK there. It just...

I have had mine only a few months, but the factory mag that came with it never worked correctly. The spring comes out its hole when I...

I haven't tried it single shot - will do that at my next shooting session. Thanks!

if one of the "holes" or pellets was not lined up right it could be clipping the loading ramp as it rotated,I could be way of course,it...

I would have never even guessed to check that - thanks for the tip!

If I remember correctly I believe I had a piece of a pellet get stuck between the hammer and valve before that caused issues. Wouldn't...

for some reason my first thought was magazine problem:unsure:

I'm curious what the chrono shows.

Maybe the O-ring sealing the bolt.

Did you clean just before this accuracy aberration or after? Until you run it over a chronograph it is all guessing.

My first thought is chrono it and see if it's speed/valve related if that's good clean barrel. Or even clean barrel first if you don't...