Im afriad i hurt my wildcat bt

You should be fine.

In order to properly adjust your gun, you should start off with the 1st regulator at a minimum and the second regulator at the maximum, so you can see what the first regulator is set to, now open the first regulator to your preferred settings.

After you set the first regulator, remove the air reservoir, and turn down the second regulator all the way. Reattach the air reservoir, fill the reservoir up and then open your second regulator to it's desired pressure.

Now you can tweak your hammer spring if needed, but it's best to make sure your velocities always go up as you increase your hammer spring setting from 1 to 7, or you may have to readjust your 2nd regulator lower, or even use a heavier hammer weight. I had to add a heavier hammer weight to my Maverick VP .30cal to get the velocity that I wanted.



In any case, I doubt you damaged your gun, and you should be fine.

I can tell you from experience, don't back the reg screw out past the body of the reg. you'll be replacing the top o-ring. It's not hard to get to, but it's a PITA to get off and on the screw stem.