FX Power Wheel MK II

Bobbybeef · Aug 22, 2024

I have 2 crowns MK II one of them the power wheel turns no problem the other the wheel will not turn unless i take the wheel off and turn with a wrench anyone no what could be the problem i looked on you tube and they only take apart MKI which is not the same not talking about the hammer wheel its the power wheel. Any sugestions?

Bramezy · Aug 22, 2024

The inner hammer tension adjustment maybe too tight? It drives the cam against that wheel and sounds maxed out. Uses a 1.5mm allen to adjust.

Bobbybeef · Aug 23, 2024

Bramezy said:
The inner hammer tension adjustment maybe too tight? It drives the cam against that wheel and sounds maxed out. Uses a 1.5mm allen to adjust.

No its not the hammer wheel its the other wheel the port wheel i should have said port wheel when i typed my question. Brain freeze

Corvid_hunter · Aug 23, 2024

My MK2 was initially very hard to turn but is better now. Maybe it needs some time to break in?

Mrshosted · Aug 23, 2024

Something sound’s dirty, I’d start with some disassembly and cleaning.

cosmic · Aug 23, 2024

air flow restrictor ??

Scotty1 · Aug 23, 2024

Mine was over loctite-ed, I disassembled and cleaned up and it’s been good. Mine would tighten the knob when trying to change the setting, so it would jam. I could turn it counterclockwise only.

Search

Search

FX Power Wheel MK II

Bobbybeef

Member

Bramezy

Member

Bobbybeef

Member

Corvid_hunter

Member

Mrshosted

Member

cosmic

Member

Scotty1

Member