What did you do airgun related today.
- Thread starter Florida_Man
- Start date
Still need to level and zero, but here is my just had-to-have in the dirty .30 caliber (can't wait to take a pest):
Upvote 0
Received my GX-E-5K1. Grease pot came damaged from the cover rubbing on it during transit 
. Emailed GX and they are sending a new pot. This makes the cs4 look like a toy. Cast iron gearbox / crankcase. 
. Emailed GX and they are sending a new pot. This makes the cs4 look like a toy. Cast iron gearbox / crankcase. Upvote 0
Please make follow up posts maybe even in the pump section. I have looked a lot at this compressor. Not talked about a lot but it lands nicely in between the cs4 and 5k2. Curious on large bottle fill times. Looks niceReceived my GX-E-5K1. Grease pot came damaged from the cover rubbing on it during transit
Upvote 0
Turned my .25 epoch into 30 cal. Cleaned the minus liner really well with a patchworm kit and put it all together. A bit bummed as it didn’t shoot pellets at all under normal velocity (870-880). Had to bring it up in the mid 920’s for it to shoot well. Lots of air consumption. Was really looking to run it in the mid to upper 70 fpe range. Will definitely spend most of its life with .25 33.95 at 900. Those are super accurate at that speed and give a good shot count.
Upvote 0
Will do.Please make follow up posts maybe even in the pump section. I have looked a lot at this compressor. Not talked about a lot but it lands nicely in between the cs4 and 5k2. Curious on large bottle fill times. Looks nice
Upvote 0
Install the custom 218 magazine on my K1 tested a bunch of different sample slug. Some of them shot well, but even more gave me flyers. I'm almost certain that I have to get the barrel aligned to this magazine since it is slightly smaller (new mag 49.76mm wide vs 49.96mm) i will put the original magazine back on until I run out of .223 slugs
Upvote 0
sounds like a trip to kelly, one thing you can bet is...when you get it back it will be in perfect order !!
Upvote 0
That I know! But I currently have like 600 .223 slugs so once I'm out it'll go straigh over there.sounds like a trip to kelly, one thing you can bet is...when you get it back it will be in perfect order !!
Upvote 0
Tore down the top end of my GX CS2 pump, cleaned and greased it. Needed to do something positive as I shot far below average today - in great shooting conditions.
Upvote 0