I just ordered a Skout EVO and need suggestions for a bag rider that will attach to the skelton shoulder stock.
I will be using this for benchrest.
Thanks for the assist!
I will be using this for benchrest.
Thanks for the assist!
Skout Skout EVO bag rider for Skeletonized shoulder stock
- Thread starter CurtisNelson
- Start date
https://sabertacticalinc.com/products/fx-panthera-bag-rider-st0064
Use blue loc tite on the set screws when you install it...
Use blue loc tite on the set screws when you install it...
Upvote 0
Are you a handy fabricator ?
See: https://www.airgunnation.com/threads/fabricated-a-custom-bag-rider-arm-for-the-skout-snazzy.1328972/
See: https://www.airgunnation.com/threads/fabricated-a-custom-bag-rider-arm-for-the-skout-snazzy.1328972/
Upvote 0
That looks nice - and hand made, even better. Electrons were my area of engineering expertise. 30 yr field service eng but not a fabricator.....Yet. Thanks for the link.
Upvote 0
UPDATE:
I had bought a Saber Tac benchrest monopod last year for the PA cup and wanted to see if I could adapt it to work on my EVO w/ skeletonized butt stock that is narrower at the bottom than the top. Here’s the result: STac uses M5 socket head cap screws that recess into the stock mounted piece. (hard to find)
I found the M4-0.7 pan head is small enough to fit in the recess.Use a 60mm screw on top and a 50mm on the lower mount point. Put a couple washers between the stock and the lower mount point to get the adapter vertical. Nylocks and M4&M5 washers under them span the gaps.
Also, add M4 washers under the cap head in the recess as necessary to minimize the screw protrusion past the Nylocks
I had bought a Saber Tac benchrest monopod last year for the PA cup and wanted to see if I could adapt it to work on my EVO w/ skeletonized butt stock that is narrower at the bottom than the top. Here’s the result: STac uses M5 socket head cap screws that recess into the stock mounted piece. (hard to find)
I found the M4-0.7 pan head is small enough to fit in the recess.Use a 60mm screw on top and a 50mm on the lower mount point. Put a couple washers between the stock and the lower mount point to get the adapter vertical. Nylocks and M4&M5 washers under them span the gaps.
Also, add M4 washers under the cap head in the recess as necessary to minimize the screw protrusion past the Nylocks
Upvote 0