FX FX Impact M4 items to 3D print

Jump to latest Follow Reply
IMG_7597.JPEG
 
  • Like
Reactions: Impact701
Upvote 0
www.thingiverse.com

3EqualstimesthreeD's Thingiverse Profile

If you liked anything you printed here, please leave a like, comment and picture of your make (Also negative is welcome, I try to learn from you also). It would make my channel more visible and it would also make me feel good when I see people like what I do. Remember, these are free for you...
www.thingiverse.com www.thingiverse.com

If you need adjustment knobs for your BENRO B-4, made a set.
 
  • Like
Reactions: JohanG
Upvote 0
I am awaiting to receive my first Impact M4 Sniper hopefully later this week. So since I am a Left shooter I wanted to be prepared. So I did a left and Right version based on a thingiverse left shooter version i found. Mine is more solid than the one found - and also shaped more advanced than a radius. I Printed the Left and Right in Petg with Fuzzy skin on - for the first time and result was surprisingly good - I think i must have totally underestimated this feature.

But thanks for sharing but Sorry "Itsme Nobady", but I am a bit conservative for the look.

20250316_113911.jpg
20250316_113933.jpg
 
Upvote 0
engfred said:
I am awaiting to receive my first Impact M4 Sniper hopefully later this week. So since I am a Left shooter I wanted to be prepared. So I did a left and Right version based on a thingiverse left shooter version i found. Mine is more solid than the one found - and also shaped more advanced than a radius. I Printed the Left and Right in Petg with Fuzzy skin on - for the first time and result was surprisingly good - I think i must have totally underestimated this feature.

But thanks for sharing but Sorry "Itsme Nobady", but I am a bit conservative for the look.
Click to expand...
All good. In my opinion round design pushes your jaw/cheek to the side and doesent give too much rest for the cheekbone so can anchor the eye decently. Thats one reason why I decided to create more spacey eye aligment. Especially with TRS rail, you have higher scope rings and its so annoying to lift your eye higher and lost resting contact from stock a bit. But whatever works for you. :)
 
Upvote 0
Good point - you might be right - but with my fat cheeks - I don't think the can catch any edges anyway.... :)

But anyway I bought two new set of low scope mounts, since my Delta wolf has adjustable mounts and by that i had to install 10 mm spacers.
So for start the Deltawolf scope will be lovered about 10 mm. And with that information - I thought i will experience the same with the M4.

So to be sure - I also printed two spacers of 5 mm each for the M4 to be able to find the right height.
My Crown Wallnut stock has always been too low, and that is quite annoying to find the right eye position.

Best regards
 
Upvote 0
You must log in or register to reply here.
Top Bottom
Back
Home
Forums
Resources
Menu