This is a much more economical route if your wanting to try out your Raptor as a big bore..
the barrel is a .35 from a Kral bighorn that I turned down to fit my raptor mini, I removed the choke from the muzzle and had my local gunsmith cut a new crown for me.
21” overall length.
New 35 probe I ordered from JSAR and it uses a 35 cal mag from an AEA challenger which is surprisingly a direct fit.
In my Raptor mini I managed 130fpe however in a full size version or an HP model one could get well north of that.
Accuracy was about an inch at 50 yds with NSA 79 grain slugs. Jsb pellets were much better than that.
I’m asking $125 shipped to your door inside conus.. and that’s for barrel, one mag & probe.
Side note- the “machining” done by yours truly on the breech end is not the prettiest thing and what I would call rough. With that being said , it isn’t able to be seen once installed and is a very snug fit.
the barrel is a .35 from a Kral bighorn that I turned down to fit my raptor mini, I removed the choke from the muzzle and had my local gunsmith cut a new crown for me.
21” overall length.
New 35 probe I ordered from JSAR and it uses a 35 cal mag from an AEA challenger which is surprisingly a direct fit.
In my Raptor mini I managed 130fpe however in a full size version or an HP model one could get well north of that.
Accuracy was about an inch at 50 yds with NSA 79 grain slugs. Jsb pellets were much better than that.
I’m asking $125 shipped to your door inside conus.. and that’s for barrel, one mag & probe.
Side note- the “machining” done by yours truly on the breech end is not the prettiest thing and what I would call rough. With that being said , it isn’t able to be seen once installed and is a very snug fit.
Last edited:
